Deep Editing & MIDI Control: SOUNDDIVER SETUP TROUBLE-SHOOTING
7•15
name, but the selection should be fairly obvious.
3. Make sure that the Device ID is set to 1.
4. On the right hand side of the Memory Manager, click on the title bar that says
User Programs. This will highlight all 36 of the user preset locations that are
currently blank.
5. Now click on the left-most icon in the upper left of the Memory Manager. It
should look like a little keyboard with an arrow coming out of it and a small
question mark. This requests the current programs from the Flextone. At this
point, you should see all the patch names fill in, and you’re good to go.
To Next Page
Loading...