Congratulations on purchasing your UK made Linear Amp Gemini HF-1K
linear amplifier.
The amplifier covers all Amateur bands from 472KHz** to 50MHz (including
5MHz)
The amplifier is housed in an all aluminium chassis. Front and rear panels are
anodised finish. Top and bottom chassis panels are epoxy powder coated.
The major internal components sit on a 3mm internal aluminium baseplate
that ensures a robust and rigid unit and provides additional heat sinking. This
also enables the external panels to largely free of any fixing screws thus
enhancing its clean lines.
Control is via a full colour touchscreen display.
The amplifier has a diode switched tx/rx changeover circuit allowing full break-
in CW operation (QSK) at full output up to 50wpm.
The current version of this manual is available to download on our website at
http://www.linearamp.co.uk/ghf_software.html
Unpacking
The following items are included:
The linear amplifier itself
Mains power lead
Spare fuses
Phono plug for PTT
This manual
Please unpack all items on arrival and check carefully for any signs of
damage in transit. Please report back to us immediately if there are any
issues.
We recommend you keep the purpose made packaging in case you need to
transport your amplifier or return it to us for repair in the future. The
packaging is designed to allow transportation safely over standard courier and
postal networks.
**Operation on 472KHc requires the use of an external Low Pass Filter (not supplied)
To Next Page
Loading...