Need help?Do you have a question about the Linear Aluminum Recumbent Bicycle and is the answer not in the manual?
Ensure all assembly instructions have been correctly followed for proper bike function.
Confirm that all required adjustments have been performed for optimal performance and safety.
Carefully read and adhere to all provided safe riding rules and guidelines.
Always check the recumbent bicycle before each ride to ensure it is in safe working order.
Perform all necessary maintenance tasks as outlined in the manual to keep the bike in good condition.
Know how to operate all standard and accessory equipment included with the recumbent.
Ensure anyone using the recumbent receives full instruction on its operation.
Comply with all applicable traffic, registration, and equipment laws.
Adhere to all vehicle operation laws, traffic regulations, signs, signals, and markings.
Ride on the right side of the road, single file in groups, maintaining safe distance.
Exercise extreme caution at intersections; walk bike across busy ones and watch for traffic.
Be aware of car doors opening or vehicles pulling out from driveways and alleys.
Use proper hand signals for turns and stops; keep both hands on handlebars when not signaling.
Watch out for drain grates, soft shoulders, and other potential road hazards.
Be extra cautious on wet, gravel, or leaf-covered surfaces; stopping distance increases.
Never carry passengers unless in a properly mounted protective child carrier.
Never carry packages that could interfere with your vision or control of the bicycle.
Always give pedestrians the right of way and ride on marked bikeways when available.
Exercise double caution when riding at dusk, as most accidents happen during this time.
Keep the bicycle in good mechanical condition for safe operation and performance.
Ride defensively, always watching out for other vehicles and potential hazards.
Always wear an approved helmet, even on short rides, to reduce injury risk.
Detailed steps for releasing brakes and securely mounting the front and rear wheels.
Instructions on adjusting the angle of brake levers and tightening shifters for comfort.
Guide for mounting the seat assembly using the quick release skewer and seat braces.
Steps for attaching the steering link and adjusting its length for proper rider position.
Provides guidelines for proper adjustment of quick release levers, including tightening and release forces.
Recommendation against cutting seat rods; advises purchasing adjustable seat rods.
Suggestions for alternative tire sizes and types for reduced rolling resistance.
Guidance on mounting water bottle cages and pumps using various methods.
Highlights the necessity of a mirror due to limited rear visibility and mounting challenges.
Recommends ordering fairings through ZIP DESIGNS and provides contact information.
Details on mounting a rack adapter, emphasizing correct alignment to avoid rubbing the wheel.
Information on where the headlight mount attaches to the front fork and how to order one.
Instructions for mounting a chain idler on the frame to secure the chain.
Explanation of bar ends for users who have trouble reaching the brakes.
To Next Page
General