40
ACCOUNT NUMBER
✦ The account number entered for the
communicator must be 4-digits long.
✦ The factory setting for the account number is
0000.
STEP #88 Enter an account number from 0000 to 9999
using this step.
PRIMARY TELEPHONE NUMBER
✦ The primary Central Station telephone number
can be up to 20-digits long.
✦ Digits 0-9 can be used.
✦ Delays and special characters can be entered in
the telephone number (see below).
STEP #89 Enter the primary telephone number using this
step.
SECONDARY TELEPHONE NUMBER
✦ The secondary Central Station telephone
number can be up to 20-digits long.
✦ Digits 0-9 can be used.
✦ Delays and special characters can be entered in
the telephone number (see below).
STEP #90 Enter the secondary telephone number using this
step.
✎ NOTE: To remove the secondary telephone
number, enter step number 90 then press TEST.
SUPERVISORY OR PAGER TELEPHONE NUMBER
✦ The supervisory Central Station or pager
telephone number can be up to 20-digits long.
✦ Digits 0-9 can be used.
✦ Delays and special characters can be entered
in the telephone number (see below). If this is
a pager number, enter enough delays for the
phone to answer. Then, enter the number to be
dialed.
✦ End a pager number with the completion
character (usually a pound (#) character).
STEP #91 Enter the supervisory or pager telephone number
using this step.
✎ NOTE: To remove the supervisory/pager telephone
number, enter step number 91 then press TEST.
TELEPHONE NUMBER DELAYS AND SPECIAL CHARACTERS
✦ When creating telephone numbers with
programming Steps 89, 90, & 91, use the
following keys to add dialing delays or special
characters.
✦ Press the key to place a 1-second dialing
delay at the start or anywhere in the middle of
the telephone number.
✦ Pressing the key as the last digit of the
telephone number will place a pound
character at the end of the telephone number.
✦ Press the FIRE key to place a 5-second dialing
delay anywhere in the telephone number.
✦ Press the CHIME key to place a star
character
anywhere in the telephone number.
PROGRAMMING STEP #88
ENTERS STEP NUMBER
4-DIGIT ACCOUNT NUMBER
STORES VALUE - 1 BING
PROGRAMMING STEP #89
ENTERS STEP NUMBER
UP TO 20 DIGITS FOR THE
PRIMARY NUMBER
STORES VALUE - 1 BING
PROGRAMMING STEP #90
ENTERS STEP NUMBER
UP TO 20 DIGITS FOR THE
SECONDARY NUMBER
STORES VALUE - 1 BING
PROGRAMMING STEP #91
ENTERS STEP NUMBER
UP TO 20 DIGITS FOR THE
SUPERVISORY/PAGER
NUMBER
STORES VALUE - 1 BING
ADDS A 1-SECOND DELAY
(START OR MIDDLE OF NUMBER)
ADDS A POUND (#) CHARACTER
(END OF NUMBER)
ADDS A 5-SECOND DELAY
(ANYWHERE IN NUMBER)
ADDS A STAR ( ) CHARACTER
(ANYWHERE IN NUMBER)
To Next Page
Loading...