linergo 4-MEM ECS Plus User Manual

2-5
Sleep Mode
The display may go into Sleep Mode after periods of inactivity, which will be indicated by a blank screen.
To wake the handset up from this Sleep Mode press either the Up or Down arrow button.
Start Up
When the table is plugged in for the first time immediately press down arrow
Three dashes will display, along with the reset symbol
When the table reaches its lowest position it will be reset. Please allow approximately 10 seconds for
the system to calibrate (display will go blank). The table is now ready for use.
Under normal conditions the display automatically shows the layout as below. This may take 2 to 5
seconds.
If the display continues to show three dashes the table is still in Reset mode.
In that case, press the down button until the table is at the lowest position.
Settings
By pressing the up and down buttons Simultaneously you enter the Settings Menu. You
are now able to scroll between the Settings Menu options by pressing the up and down arrow buttons.
To exit the menu repeatedly press the down arrow until the primary display returns to the screen.
Settings Menu Options

linergo 4-MEM ECS Plus Specifications

General

Brand	linergo
Model	4-MEM ECS Plus
Category	Monitor
Language	English