EasyManuals Logo

linergo 4-MEM ECS Plus User Manual

linergo 4-MEM ECS Plus
5 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
4-5
4 . Waiting for button
5. Waiting for button release
6. Motor lost
7. Overcurrent
8. Overheating*
9. Low voltage
10. High voltage
11. Motors far apart - reset required
12. Destination above upper limit
13. Destination below lower limit
14. Internal error
15. Collision detection
Thermometer will be flashing, wait 10 mins. to allow the motor to cool.
Calibration (CAL)
Adjust the default height to the actual measured height by using the up and down arrow buttons.
Setting Memory Buttons
To set the memory buttons use the up and down arrow to navigate to the desired height. Rapidly
press and release the up and down arrow buttons simultaneously three times.
The letter "S" will display on the screen.
Press and release the memory button you've chosen for the current height and the display will change
to "S1", "S2", "S3", or "S4".
To reach the memory setting after it has been programmed, press and hold that memory button until
the table stops moving.
rES- Reset
rES for Reset. will force the system into Reset mode.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the linergo 4-MEM ECS Plus and is the answer not in the manual?

linergo 4-MEM ECS Plus Specifications

General IconGeneral
Brandlinergo
Model4-MEM ECS Plus
CategoryMonitor
LanguageEnglish