EasyManua.ls Logo

Link-Belt RTC-8090 II - User Manual

Default Icon
302 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Operator’s Manual
Preface
BOOK1231N4062122
Crane Serial Number
The crane serial number is on the Crane Rating Manual
in the lower right interior of the operator’s cab. The
crane serial number should always be furnished when
ordering parts for the crane, or when corresponding
with the Link- Belt Distributor or the Factory regarding
the crane. The serial number is the only method of en-
suring that the correct parts will be furnished.
In the event the serial number cannot be found on the
Crane Rating Manual, a number is stamped on top of
the bumper on the right side of the carrier and on the
two position swing lock weldment. This number can
then be used to help to identify the crane.

Questions and Answers

  • J
    jsmithAug 7, 2025
    What to do if Link-Belt RTC-8090 II cannot tune to radio station?
    • A
      amanda82Aug 7, 2025
      If your Link-Belt Construction Equipment cannot tune to a radio station or the auto-seek function isn't working, it might be due to a disconnected antenna cable. Ensure the antenna cable is firmly inserted. Alternatively, the signals might be too weak. In this case, try selecting a station manually.
  • G
    gallenAug 17, 2025
    Why Link-Belt RTC-8090 II Construction Equipment has no power?
    • H
      hcoxAug 17, 2025
      If your Link-Belt Construction Equipment has no power, there are a couple of things to check. First, ensure the accessory switch is turned ON. If the power supply is properly connected to the crane's accessory terminal, switch the ignition key to 'ACC'. Also, check the fuse. If it's blown, replace it with a new one.
  • N
    Nathan HendersonAug 27, 2025
    How to fix no sound on Link-Belt Construction Equipment?
    • B
      Bobby BarnesAug 27, 2025
      If you're experiencing no sound from your Link-Belt Construction Equipment, here are a couple of things you can check: * First, make sure the volume isn't set too low. Adjust it to an audible level. * Second, verify that all wiring connections are properly connected.

Link-Belt RTC-8090 II Specifications

General IconGeneral
BrandLink-Belt
ModelRTC-8090 II
CategoryConstruction Equipment
LanguageEnglish

Related product manuals