- 3 -
Install a necessary warning board of danger near exposed AC or DC voltage terminal.
Keep far away from exposed cables and equipment.
Do not block or go around the protective device.
Do not mechanically damage the battery pack.
Do not modify the battery pack.
Do not allow the battery pack to be in contact with water.
Do not heat the battery pack. Operate only within the permitted range of
temperature.
Do not “short out” the battery pack.
Do not continue to use the battery pack if it is shorted out.
Do not over discharge the battery pack.
Avoid contacting any escaped electrolyte.
Please operate carefully, so as to protect Power Work S2 and its components from
being damaged during transportation. Do not strike, pull, drag or tread on Power
Work S2. Do not make Power Work S2 affected by any brute force. To prevent from
damage, before preparation for installation, please put Power Work S2 in its
transport package.
In case of failure, please do neither use Power Work S2, nor try to dismount, repair,
falsify or modify Power Work S2. The battery cell in the power support cannot be
replaced.
The range of temperature for recharge of battery pack should be 10°C to 45°C. If the
battery pack is recharged under the temperature beyond this range, it may make the
battery pack hot or disconnected. If the battery pack is recharged under the
temperature beyond this range, it may make its performance worse or reduce its
expected service life.
Avoid installing it in a wet environment.
Do not clean Power Work S2 or expose Power Work S2 to flammable or irritant
chemicals or steam.
Do not use any part or accessory not designated in this Manual, or any part or
accessory not directly purchased from Beijing Linkdata Technology Co., Ltd. or it’s
nominated agents (hereinafter referred to as Linkdata) or certifier of Linkdata.
Make sure that there is no snow covering on the top of or around Power Work S2.
Do not paint any part of Power Work S2, including any internal or external
component, e.g. outer shell.
When installing Power Work S2 in the garage or near vehicles, install Power Work S2
to the side wall or the place higher than the vehicle bumper to ensure visibility.
Do not block the vent.
Do not lift or move it by yourself.
If Power Work S2 is no longer used, dispose of it via a registered battery recycling
site or company.
Do not touch or replace other components except for wiring terminals without
authorization. Please operate according to the method described herein. Otherwise,
Linkdata will not undertake any responsibility or warranty in case of any personal
injury or damage to the battery.
To Next Page
Loading...