- 2 -
Safety Instructions and Warnings
Danger! It refers to the circumstance that may cause personal injury or
death.
Caution! It indicates that there may be dangerous situations that will
result in equipment damage.
It points out important suggestions that may bring the best results, but
which are not related to safety and damage.
The installation should be carried out strictly in accordance with the operating
procedures mentioned herein step by step.
All personnel participating in field installation, wiring and commissioning must wear
safety helmets, safety goggles, safety shoes, safety gloves and insulating gloves. The
detailed requirements are as follows:
To prevent from an electric shock, all equipment must be disconnected at least 5
minutes before any installation or maintenance.
Children must be kept away from Power Work S2.
Before installation and wiring, make sure that no equipment is energized, and ensure
that AC and DC circuit breakers are disconnected.
Do not install Power Work S2 near any heating device.
Do not insert any foreign matter in any part of Power Work S2.
Do not expose Power Work S2or its components by the flame.
Do not immerse Power Work S2or its components in water or other liquid.
When Power Work S2 is operated or stored at a temperature exceeding the specified
range of temperature, it may be damaged.
Do not touch Power Work S2 with wet hands.
Please avoid use of any damaged power cables or wires, etc.
Do not touch Power Work S2 or connect to any cable of Power Work S2 at the peak
period of electricity utilization.
Do not use any power supply exceeding the specified voltage.
Do not perform any work related to wiring when it is powered on.
Do not connect it to any equipment except for those specified.
Do not put Power Work S2 on an unstable surface or on a surface with the strength
insufficient to support Power Work S2.
Do not carry out installation when it rains.
In case of appearance of smoke or occurrence of abnormal heat, unusual odor or
sound, or the battery falls down or is damaged, turn off the switches of all circuit
breakers, and stop using Power Work S2.
Power cables and wires should be connected firmly.
Do not work separately. In case of emergency, the existence of the other person will
be crucial.
To Next Page
Loading...