1-800-237-5465 Applied Computer Systems, Inc. www.acs-linksystems.com
23) Hold in the Alt button and press F1 to switch back to the shutdown menu.
24) Press r (as in “reboot”) to reboot the system.
25) Verify that the controller software starts as usual and that the calibration is correct. At this
point you may again use the touchscreen to control your LinkSystem.
If at any point you lose your place or the directions do not seem to apply to the screen you are seeing,
first try going immediately to step #22, finish the directions through #24, and then either return to the
beginning of the directions as if you are starting from scratch or contact ACS for assistance.
If calibrating the touch screen does not appear to fix your problem, call Applied Computer Systems,
Inc. at 800-237-5465 for technical support.
To Previous Page
Loading...
Need help?
General