Link 904 – User Manual 4
1. INSTALLATION
1.1 GETTING CONNECTED
Insert the telephone plug into the telephone socket. If
this socket is not present contact your network operator. Check
the telephone is operating correctly by pressing the 'SPEAKER ON'
button and listening for dial tone.
Also supplied with the telephone is a Stub Cable which can
be used to install the unit in locations where a telephone socket is
not practical.
This need to be connected as follows:
• Yellow Wire - Earth
• Green Wire - Line A Conductor
• Red Wire - Line B Conductor
• Black Wire - Shunt Wire
1.2 WALL MOUNTING
The Link 904 is designed to be wall mounted using the
screws provided.
The excess line cord can be wrapped up using the space
provided at the bottom of the unit. If required the cord can then
run out the unit using the snap out exit at the bottom of the unit.
If the unit is being placed in a bathroom you may want to
ensure a proper waterproof shield. This can be achieved by
applying silicone glue between the unit and the wall.
2. TELEPHONE SETUP
2.1 MICROPHONE SENSITIVITY SETTING
The Link 904 is design for use in a wide variety of
locations. To cater for these different installation conditions it is
possible to adjust the microphone sensitivity of the unit using the
following procedure.
- Press the [SPEAKER ON] button
- Press the [STORE] button (located under the memory
label)
- Press the following sequence of keys:
[0][0][1][2][3][0][3]
- Select the sensitivity
(low to high 0,1,2,3,4,5,6,7,8,9,M1,M2,M3)
To Next Page
Loading...