3
INSTALLATION
(1) Take out the lamp body, connect the rods and spike in different combinations
based on the height you need.
(2) Insert the assembled light into the ground vertically.
button switch
1.The default mode of the product is OFF mode. Press the button to adjust
modes when using the light.
OPERATION GUIDE
2. This product is not only solar powered but rechargeable with Type-C connection.
Please follow below steps to charge the light:
Pull out the rubber protective port cover, connect the light with your own Type-C
cable and adapter (both not included). The indicator will turn to orange while
charging and turn off when charged to the full. Then unplug the cable and fit tight
the rubber cover against water and dust.
Suitable Adapter Output: 5V, 500mA(or above)
Type-C
To Next Page
Loading...