5
Connect one end of an Ethernet
network cable (included) to the
ETHERNET port of the Gateway.
Connect the other end to your
cable/DSL modem.
Connect one end of a different
Ethernet network cable to the AUX
port of the Gateway. Connect the
other end to the Ethernet port of
your PC.
Power on the cable/DSL modem.
Connect the included power
adapter to the Gateway’s power
port, and then plug the power
adapter into an electrical outlet.
Press the On switch to power on
the Gateway. The power LEDs on
the front panel will light up as soon
as the Gateway powers on.
Power on your PC.
NOTE: Make sure your PC’s Ethernet adapter is set to obtain an
IP address automatically. For more information, refer to Windows
Help.
E.
F.
G.
H.
I.
Ethernet ConnectionEthernet Connection
AUX ConnectionAUX Connection
Power PlugPower Plug
To Next Page
Loading...
