Chapter 2
Configuration
7
USB Ethernet Adapter
Click 5. Start, click Control Panel, and then double-click
Device Manager. The Device Manager opens and
displays a list of your computer’s devices.
Device Manager
Double-click 6. Network adapters, and then double-
click ASIX AX88772 USB2.0 to Fast Ethernet Adapter
to display the Adapter’s Properties window.
Fast Ethernet Adapter Properties—General tab
Click the 7. Advanced tab, and then use the Property
and Value drop-down menus to set the properties as
follows.
Connection Type Set this to AutoSense.
Flow Control Set this to Rx & Tx Enable.
QoS Packet Tagging Set this to Disable.
Wake Up Set this to Disable.
Wake-Up Frame Type Set this to Windows Default.
Fast Ethernet Adapter Properties—Advanced tab
Click the 8. Power Management tab. Select Allow the
computer to turn off this device to save power. Click OK
to save the property settings.
Fast Ethernet Adapter Properties—Power Management tab
Congratulations! The installation of the USB Ethernet
Adapter is complete.
For more information about networking under
Windows Vista, refer to your Microsoft Windows Vista
documentation.
To Next Page
Loading...
Need help?
General
