To Next PageTo Next Page
Need help?Do you have a question about the Linksys PAP2 and is the answer not in the manual?
General| Ports | 2 FXS ports |
|---|---|
| Protocol Support | SIP v2, SDP |
| Voice Codecs | G.711, G.726, G.729A/B, G.723.1 |
| Network Protocols | TCP/IP, UDP, DHCP, DNS, TFTP, HTTP |
| Security | Password protected system reset |
| Connectivity | 10/100 Mbps Ethernet |
| Power Supply | 5V DC |
Procedure to reset the Linksys PAP2 to its factory default settings for initial setup.
Connecting an analog telephone to the PAP2's Phone 1 port.
Connecting the PAP2 to the broadband network via Ethernet cable.
Connecting the power adapter to the PAP2 device.
Ensuring the PAP2 automatically acquires an IP address from the DHCP server.
Verifying the PAP2 has a valid IP address and recording it.
Steps to resolve problems when the PAP2 fails to obtain a valid IP address.
Instructions to access the PAP2's web-based configuration page.
Configuring the primary line with Linhagratuita service details.
Configuring the secondary line if using a second Linhagratuita account.
Settings related to the Streaming Audio Server functionality.
Configuring NAT, IP TOS, and Network Jitter Level.
Configuring SIP port, 100REL, and call features like blind transfer.
Settings for SIP proxy, outbound proxy, and registration parameters.
Entering Display Name, User ID, Password, and Auth ID.
Enabling and configuring various supplementary phone services.
Settings for preferred codecs, silence suppression, and echo cancellation.
Customizing the dial plan and configuring FXS port polarity.
Configuration for making outbound calls without an IVR prompt.
Example configuration for Proxy and Registration with specific values.
Example of filled Subscriber Information fields.
Detailed settings for supplementary services like Call Waiting and CID.
Configuration for audio codecs, echo, and dial plan customization.
Customizing FXS port polarity settings.
Configuration for outbound calls requiring user PIN and destination entry.
Example configuration for Proxy and Registration settings.
Example of subscriber details including User ID and Auth ID.
Configuration for entering destination details in Outbound IVR.
Example configuration for proxy and registration for a dual-port adapter.
Example of subscriber details for a dual-port adapter.
Configuration of supplementary services like Call Waiting and CID.
Settings for audio codecs, echo, and dial plan customization.
Information needed for static IP configuration: IP Address, Gateway, Subnet Mask.
Step-by-step guide to manually configure static IP settings on the PAP2.
Procedure to confirm the correctly entered static IP address settings.
