csdata brasil Ltda. / Tel. +55 81 3422 1714 / Fax. +55 81 3422 1984 / VoIP 2031
Web: www.linhagratuita.com.br / E-Mail: voip@linhagratuita.com.br / CNPJ: 07.196.259/0001-07
STEP 2 Verify & Configure your IP address
If you have purchased your Linksys PAP2 adaptor from Linhagratuita, skip this
section and proceed to Section B.
If your network utilizes a DHCP Server to assign IP addresses to network devices,or if you are
connecting the PAP2 to a home router such as Linksys or Netgear, please do the following:
A. First you must verify that your PAP2 will acquire an IP adress automatically.
1. Pick up the phone connected to the “Phone 1” port of the PAP2 and enter “* * * *”.
You will then hear a voice say, “Linksys configuration menu.”
2. Press the keys 110 # on your analog phone.
3. Press # to enable DHCP.
4. Press to save your configuration settings. Hang up the phone and wait for a couple
of minutes.
B. Next, you need to verify that your PAP2 has a valid IP address. Be prepared with
pen and paper, and proceed with the following:
1. Pick up the phone connected to Phone 1 of the PAP2 and enter “* * * *”. You will
hear a voice prompt say, “Linksys configuration menu.”
2. Press keys 1 1 0 # on your analog phone. The system will then read back the IP
address of your PAP2. Please write this down.
If the IP is 0.0.0.0, your PAP2 does not have a valid IP address. In this case, you
need to:
1. Hang up the phone, then unplug and replug your PAPA2 power cord.
2. Wait 2 minutes, then check the IP again (see STEP 2).
3. If the automated voice again says your number is still 0.0.0.0, there are three
reasons for this:
a. Your DHCP Server is not assigning an IP address to the PAP2. In this case,
contact your network administrator or ISP for assistance.
b. Your network does not have a DHCP server. In this case, you must
configure your IP manually (See Page 7).
c. You have purchased a Static IP. In this case, configure your IP manually
(See Page 7).
4
To Next Page
Loading...
Need help?
General
