LINKSYS WCG200 User Manual
2
2
.
.
1
1
-
-
3
3
I
I
n
n
s
s
t
t
a
a
l
l
l
l
a
a
t
t
i
i
o
o
n
n
P
P
r
r
o
o
c
c
e
e
d
d
u
u
r
r
e
e
f
f
o
o
r
r
W
W
i
i
r
r
e
e
l
l
e
e
s
s
s
s
1. Make sure your computer meets the system requirements.
2. Connect a coaxial cable (supplied by the local Cable Television Company) to the CABLE
connector on the modem.
3. Plug the power adapter into the POWER connector of the modem.
4. Plug the other end of the power adapter into a power outlet.
5. Check CABLE LED. If it is solid ON, the Cable Modem is on-line now. If it is not, contact
your service provider.
6. Install the wireless card driver and verify the wireless setting as below:
---The default SSID: linksys
---WEP encryption is disabled. Authentication Type is Open System or Shared Key.
---Use Infrastructure connection mode.
7. Check that the TCP/IP protocol is installed on your wireless client PC. Configure it to get a
dynamic IP from the
L
INKSYS WCG200.
Note: You can go to Chapter 3.3 “Setting TCP/IP on client PC” now
8. When the connection is established, the client PCs can access the Internet or remote network
through the
L
INKSYS WCG200.
Below shows the connection status among the cable modem and your computer.
To Next Page
Loading...
