8
Chapter 4: Fast Setup for the Wireless-G Game Adapter
Overview
Wireless-G Game Adapter
Chapter 4: Fast Setup for the Wireless-G Game Adapter
Overview
The Fast Setup directions are provided for any gamer playing over a wireless network with WEP encryption
disabled and SSID broadcast enabled. If you need to change the Game Adapter’s settings to match those of your
wireless network, proceed to “Chapter 5: Setting up the Wireless-G Game Adapter for PlayStation
®
2 or
GameCube
™
.” If you are connecting the Game Adapter directly to your Xbox, proceed to “Chapter 6: Setting up
the Wireless-G Game Adapter for Xbox
®
.”
Instructions
1. If the Game Adapter will be used for head-to-head play, move the back panel switch to the Adhoc position.
If the Game Adapter will be used for Internet play, move the back panel switch to the Infrasturcture position.
2. Plug the included Ethernet network cable into the Game Adapter’s Network port.
3. Make sure your game console is powered off. Then plug the other end of the Ethernet network cable into the
Ethernet network port of your game console.
4. Plug the included power adapter into the Game Adapter’s Power port.
Then plug the other end into an electrical outlet, preferably a surge protector.
5. Power on your game console, and set it for multiplayer gaming.
Congratulations! The installation of the Wireless-G Game Adapter is complete.
Figure 4-1: Connect the Ethernet Network Cable
Figure 4-2: Connect the Power
To Next Page
Loading...
