6
Broadband WAN and Mobile Broadband
Connect the other end of the cable
to one of the yellow Ethernet ports
labeled 1-4 on the side panel of the
Router.
Repeat steps C and D to connect
additional computers or other
devices to the Router. (Additional
network cables are not included.)
Click Next.
Connect the power adapter to the
Router’s Power port. Plug the other
end into an electrical outlet.
Click Next.
The Power LED will flash for several
seconds during the self-test. It will
be solidly lit when the self-test is
complete.
If the Power LED does not stop
flashing, refer to “Appendix A:
Troubleshooting” in the User Guide
on the CD-ROM.
Click Next.
D.
E.
F.
Connect the Network Cable to the RouterConnect the Network Cable to the Router
Connect to PowerConnect to Power
Check the Router’s StatusCheck the Router’s Status
To Next Page
Loading...
