Step 4:
Insert 4 AA alkaline batteries into the TapLinker in the correct orientation
and switch it on. The TapLinker will automatically connect to the Gateway
in 5~60 seconds, as indicated by 2 solid green LEDs ( and ). These
2 LEDs will go off after being solid green for 15 seconds to save power.
The LinkTap
D1 water timer contains an inclination sensor to detect
changes in the tilt angle of the device. If the angle change exceeds a
certain threshold, the system will register that the water timer has fallen off
the faucet. You can verify the fall detection and notification process of your
LinkTap water timer by following the steps below.
To Next Page
Loading...