LINKTAP D1 - Manual Watering and Fault Detection; Manual Watering Operation; Step 6: Enable Fault Alerts; Fault Detection Function Overview

At this point, you can verify the water cut-off detection and notification
process by following the steps below:
1) Enable "Water cut-off alert" on the app;
2) Turn off the faucet completely and make ensure that no water flows out
of the faucet;
3) Press the Manual On/Off button on the device, or activate Instant mode
on the app to start watering.
Within 45 seconds, you should receive a water cut-off alert on your phone.
Manual Watering
Press the blue Manual On/Off button once to start or stop watering. You
can also disable, partially enable or fully enable the Manual button lockout
function through the app.
Step 6:
Enable all fault alert options on the app. You can now remotely access your
wireless water timer with peace of mind!
About the fault detection function:
Your LinkTap water timer contains an inclination sensor and a flow meter
sensor. Apart from being able to measure flow rate in real time, the device
can detect the following faults in a real time manner and then send push
notifications and emails to you and your nominated person, e.g. neighbor,
friends, etc.
1) The water timer falls off the faucet;
2) The water timer failed to shut down the watering properly;
3) The water timer failed to open the valve properly;