UK users please read this important safety information
Fuse replacement
This appliance is fitted with a non-rewireable 13 Amp mains plug. The plug
contains a 5 Amp fuse. If the fuse has blown it can be replaced as follows:
a) Pull out the red fuse cover/carrier.
b) Remove and dispose of the blown fuse.
c) Fit a new 5 Amp BS1362 approved fuse into the carrier and push the
carrier back into the plug.
Always ensure the fuse cover is fitted. If the fuse cover is missing do not use
the plug. Contact your Linn retailer to obtain a replacement fuse cover.
Fuses are for fire protection and do not protect against electric shock.
Mains plug replacement
Should your mains plug need replacing and you are competent to do this
proceed as follows. If you are in doubt contact your Linn retailer or a
competent electrician.
a) Disconnect the plug from the mains supply.
b) Cut off the plug and dispose of it safely. A plug with bared conductors
is dangerous if engaged in a live socket.
c) Only fit a 13 Amp BS1363A approved plug with a 5 Amp fuse.
d) The cable wire colours or a letter will be marked at the connection
points of most quality plugs.
Attach the wires securely to their respective points. The Brown wire
must go to the Live pin, the Blue wire must go to the Neutral pin, and
the Green/Yellow wire must go to the Earth pin.
e) Before replacing the plug top ensure that the cable restraint is
holding the outer sheath of the cable firmly and that the wires are
correctly connected.
WARNING
THIS APPLIANCE MUST BE EARTHED.
Replacing the fuse
Should the mains fuse blow replace it only with an equivalent part. The fuse
holder is located just below the mains inlet socket. To replace the fuse
disconnect the product from the mains supply. Using a flat blade screwdriver
remove and replace the fuse. If the fuse blows a second time there is a fault
in the product. Contact your local retailer.
Fuse ratings. See specifications section.
Mains voltage operating range. See specifications section.
Warning!! The power supply may be destroyed if a unit
designed for 115V is connected to 230V.
iii
To Next Page
Loading...