Connecting
Connect each left and right channel on the Majik DSM to the equivalent terminal on 1.
your loudspeaker using your preferred connection method (spade / banana plug / bare
wire) and ensuring a good tight connection is made in each case
Connect the Majik DSM 2. Ethernet socket to your network using a standard Ethernet
cable
If you have any external sources you wish to connect to your Majik DSM, such as a 3.
Blu-Ray or DVD player, satellite TV or games console, connect these to the appropriate
analogue, HDMI, SPDIF or TOSLINK IN socket.
If connecting HDMI video sources to your Majik DSM, you •
must also connect an HDMI cable from HDMI OUT back
to your display device to ensure video is displayed
Connect any additional source components to the back 4.
panel using your preferred connection method - use
socket 4/PH for any turntable you wish to connect (and
do not connect line level source components to this
socket)
YourMajikDSMisconguredasanMM(MovingMagnet)phonostageasdefault-•
please contact your Linn Specialist if you wish to change this to MC (Moving Coil) or
convert socket 4/PH to line level
Connect your mains cable but do not power on the unit yet5.
If you have a NAS or ripping NAS then you should also ensure this is connected to 6.
your network and powered on (
see www.linn.co.uk/nas for more info)
Thank you for purchasing the Linn Majik DSM player. This guide provides basic un-
packing and connecting information to get you started - contact your Linn Specialist for
full installation support.
IMPORTANT:
Please refer to the printed Safety Information booklet for important safety information
and refer to www.linn.co.uk/majikdsm for further documentation and help on using
your Linn Majik DSM player.
Unpacking
Removeproductfrompackagingandplaceonaatsurface•
Please retain all packaging for future transport of Majik DSM •
Contents
1 x Majik DSM player•
1 x mains lead •
1 x slimline infra-red (IR) handset (with 2 x CR2032 batteries)•
1 x Safety Information booklet•
Positioning
Placeunitonaat,stableandrigidsurface•
Place unit within range of your network router or switch•
IMPORTANT:
Linn recommend the use of separate dedicated network components, includ-
ing router, switch and wireless access point. Alternatively, a dedicated integrated
router/switch/wireless device is preferable to simply connecting the unit directly
to your home broadband router. Linn do not recommend a wireless connection
between DS player and network. See www.linn.co.uk/networks for more info
Avoid positioning the unit in direct sunlight as this can interfere with the infra-red •
(IR) sensor on the front panel
Do not stack components and avoid placing near other heat sources•
Donotblockventsorsitetheunitinacabinetwhichpreventsairowingfromfront•
to back
Allow at least 4” (10 cm) all the way around the unit for air circulation•
MAJIK DSM
QUICKSTART
To Next Page
Need help?
General
