13
TO CHECK OR ADD TO THE PROGRAM
after you have pressed
STOP o, press SKIPi and the first track in the program will be shown.
Pressing
SKIPi again will display the second track, and so on. The
display shows the track number, followed by its position in the
program. So, "703" signifies that track 7 is 3rd in the program. If you
want to add more tracks, press and hold
PROGRAM until "P--A"
appears. Then release
PROGRAM and the display will show "P" followed
by the number of program slots used. Enter the additional tracks using
SKIP and PROGRAM as described previously. Press STOP o when you
have finished adding tracks.
TO PLAY THE SELECTION YOU HAVE MADE
press PLAY w.
TO PREPARE TO PLAY THE SELECTION YOU HAVE MADE
press
PAUSE p. This is useful when you are making a tape. When you are
ready to listen or record, press
PAUSE p again or PLAY w to start your
selection.
TO ADD MORE TRACKS TO THE PROGRAM after it is playing press
STOP o. You can now check or add to the program as described above.
TO CANCEL THE PROGRAM press OPEN. The program is now
cleared.
TO OMIT A SET OF TRACKS
make sure the disc is loaded but not
playing. Press and hold the pair of keys marked
PROGRAM for about 4
seconds until the display shows
P - - b
which indicates that programming mode b has been entered. Release
PROGRAM, and the display will show
P-00
indicating that the MIMIK is ready for you to enter to your selection.
Enter tracks in the same way as for programming mode A. When you
now play the disc the tracks you have entered will not be played.
To Next Page
Loading...