14
NOTES ON PROGRAM MODE While the MIMIK is playing a stored
program the A-B
REPEAT function is disabled and SKIPi or uSKIP
will skip to the next or previous track in the programmed sequence.
SEARCH y will search through the current track, and then into the
next track in
numerical, rather than program, sequence. So, you can
use
SEARCH y to break out of the stored program. If you do so though,
the program will resume at the end of the track you used
SEARCH y
to get into.
DIGITAL AUDIO DISABLE
TO DISABLE THE DIGITAL AUDIO OUTPUT press the pair of keys
marked
DIGITAL and hold them for 2 seconds. The DIGITAL indicator will
go out and no data will be transmitted from the digital output of the
MIMIK. This facility is of particular use in a Linn multi-room system
using a Linn NUMERIK D/A convertor as it allows you to switch inputs
to the NUMERIK. If you are using another dual channel D/A convertor
this facility allows you to avoid intermodulation problems between
the channels in the convertor.
TO ENABLE THE DIGITAL AUDIO OUTPUT if it has been disabled,
press the pair of keys marked
DIGITAL and hold them for 2 seconds. The
DIGITAL indicator will illuminate, and digital data will once again be
transmitted from the digital output of the NUMERIK.
USEFUL INFORMATION
PERMANENT DISPLAY By default, the MIMIK is configured to turn
the display off after about 20 seconds after the last command. If you
would prefer the display to stay on permanently, please contact your
Linn retailer who will make the simple modification necessary.
USING THE REMOTE CONTROL
The MIMIK is supplied with a small handset which controls the CD
player and provides basic control for other Linn components. The
larger handset supplied with some other Linn products may also be
used with the MIMIK.
To Next Page
Loading...