19
REMOTE INPUT
Current loop remote control input
Maximum DC current source: 20mA (short circuit protected)
Sensitivity: 5mA differential signal current
Bias voltage: 7V (to power remote IR sensor)
REMOTE OUTPUT
Current loop remote control output
Connector: RCA phono
Level: 6mA output signal current
AUDIO OUTPUT
2 stereo audio outputs
Connector: RCA phono
Output level: 2.0V rms (peak code)
Output impedance: 100 Ohms
Minumum load: 1 KOhm
DIGITAL OUTPUT
S/P-DIF Digital Audio Electrical Output
Connector: 75Ohm BNC
Level: 0.5V pp (75 Ohms)
To Next Page
Loading...