Clean the unit periodically and as soon as it is dirty.
It is recommended to clean this unit after using or before storage.
Clean the unit with a soft cloth which has been slightly moistened with lukewarm water.
Pay attention that no water drops into the seals ( to possibly damage the electronics).
Dry off the unit with a dry cloth after cleaning.
Never use solvents or agents with sand or acid parts for cleaning the cooling tank.
Never use brushes, graters, or hard and sharp tools.
Mount the refrigerator in a cool dry place away from direct sunlight.
Always allow food to cool before storing in the refrigerator.
Defrost your refrigerator periodically.
Do not set the temperature colder than the required temperature.
Do not leave the lid or door open any longer than necessary.
Always ensure that the compressor and condenser are in well ventilated area.
If you want to cut out the cooling device for a longer period, remove the plug from the
AC line or disconnect the cooling device cable from the battery.
Clean the refrigerator and leave the lid slightly open to prevent the formation of mould.
The refrigerator will stop working when it reaches the temperature you set, and will
restart after the inside temperature goes up.
The refrigerator will stop working because it has over temperature protection. (If the
compressor temperature is over 70C .)
It will restart when the compressor cools down.
If the refrigerator doesn’t work normally, please check the following steps.
· Turn off the refrigerator, and unplug the connection cable.
· Cool down for 10 minutes.
· Please check and ensure the power source is in accordance with the
requirements labeled on the rating plate.
· Please keep well ventilated.
· Connect the power again; ensure the cable is connected properly and firmly.
· Check if the unit starts and works normally.
Page 5
Warranty
12 months.
The warranty form must be returned to Lion along with a copy of the receipt.
Cleaning
Tips for energy saving
Storage
Trouble shooting
To Next Page
Loading...