Lionel Service
T
his product is built with pride by Lionel and carries a warranty to
support continued reliable operation. If service is required, bring it
and its warranty card to your local authorized Lionel Service Center. To
find the nearest dealer or Service Center, simply call 1-800-4-LIONEL or
search our website: www.lionel.com.
If you prefer a Lionel factory repair, call 810-949-4100, fax
810-949-5429, or write Lionel Service, P.O. Box 748, New Baltimore, MI
48047-0748. State the problem and the product’s purchase date. We’ll
send a return authorization letter to assure proper handling while at
Lionel. You may choose to have your product repaired by one of our
authorized Lionel Service Centers after its warranty has expired. A rea-
sonable service fee will be charged.
CAUTION: Make sure your product is properly packed to prevent
shipping damage. The shipment must be prepaid and we recommend it
be insured. Please follow these instructions carefully. This warranty
gives you specific legal rights. You may have other rights that vary from
state to state.
© 1997 L
IONEL LLC, CHESTERFIELD, MI 48051-2493
U
NITED STATES OF AMERICA
Controller functions
A
s you turn the throttle control knob to the right, power to the acces-
sory is increased.
The yellow band indicates the average power range that the acces-
sory will be operating in. The red band represents maximum power
output. Always use the minimum
power setting that will operate the
accessory.
FULLFULL
SPEEDSPEED
OFFOFF
R
The
WHISTLE/HORN but-
ton will have no effect on
accessory control.
T
O ACCESSORY CLIPS
, BINDING POSTS, OR LEADS
The DIRECTION button
will cut power to the
accessory as long as it is
held down.
Turn the voltage control
knob to the right for
more power.
The LED indicator
shows when your con-
troller is O
N.
Green band
Yellow band
Red band
Y
our Lionel 1035 accessory power system power pack is listed by
Underwriters Laboratories Inc. and has been carefully designed
and tested to ensure peak performance. The controller is equipped with
a built-in electronic circuit breaker that alternately cuts off and restores
the flow of power whenever a short circuit exists. The circuit breaker’s
action continues until the cause of the short circuit is eliminated. This
circuit breaker is incorporated into the controller to protect it from pos-
sible damage. It
WILL NOT protect electrically operated accessories, so it’s
important
to eliminate short circuits as soon as possible.
A short circuit is caused by a direct connection between the center rail
and one of the outside rails or by a direct connection between bare
wires. If too many accessories are used, your controller will exceed its
preset power limit and will begin to cycle on and off. To correct this
problem, some accessories must be removed before normal operation
can resume. For more power, see the line of Lionel high-output trans-
formers at your authorized Lionel Value Added Dealer.
After your power pack has been operating for a while, you will find it
warm to the touch. It is the nature of all electrical power equipment to
become warm when in use. If your controller is loaded to capacity, it is a
good idea to let it cool down after an hour or two of continuous use. Always
unplug the power pack from the wall when the controller is not in use.
Controller and short circuits
The power pack must be unplugged from the wall socket
when a short circuit is noticed, and the short circuit must be
corrected.
Note!
To Previous Page
Loading...
