Lionel 726 - Locking Your Locomotive into Forward Direction Only Operation

4
Transformer operations
LOCKING YOUR LOCOMOTIVE INTO FORWARD DIRECTION ONLY OPERATION
W
hentheElectronicE-unitDirectionLockswitchisintheRUNposition,yourlocomotive
sequences through a repeating pattern of operations: forward, neutral, reverse, neutral,
and so on.
To lock your locomotive into forward direction only operation, you can deactivate the
Electronic E-unit’s sequencing function. Follow the steps below and refer to Figure 1 for the
locationoftheElectronicE-unitDirectionLockswitch.
Always turn off track power before removing the locomotive from the track.
1. Turn off track power, wait three seconds, and remove the locomotive from the track. Now
slidetheElectronicE-unitDirectionLockswitchtotheLOCKposition.Yourlocomotiveis
now locked into forward direction only operation.
2. Place your locomotive back on the track. Power up the track and press the direction button
on your transformer to confirm that the locomotive is now locked into forward direction
only operation.
To restore the forward-neutral-reverse sequence, turn off power and remove your locomotive
fromthetrack.SlidetheElectronicE-unitDirectionLockswitchbacktotheRUNposition.
Place the locomotive back on the track and restore track power.
Note!
Figure 1. Switch and volume control locations
REAR
Smoke Switch
Electronic E-unit
Direction Lock switch
Volume control knob
on tender
RUN