Lionelo Aurora - Assembly and Features; Installation Guide; Cot Height Adjustment; Rocker and Wheel Lock Operation

‑ 11 ‑ EN
Installaon instrucons
1. Slide the legs of the cot (9, g. A) into the corresponding place on the frame
(g. 1). Correct installaon will signal a click.
2. Slide the stabilizaon bar (6, g. A) into the guides on both sides of the cot
frame (g. 2).
3.
Slide the carrycot base (5, g. A) into the guides on both sides of the cot
frame (g. 3).
4. Pass the harness (7, g. A) through the corresponding holes in the cot cover
(A, g. 4) and then insert the stabilizaon plate (2, g. A). Tighten the straps
by fastening over the top of the plate (B, Fig. 4).
5. Insert the maress (g. 5). The line in the cot cover indicates the maximum
permissible height of the maress used in this product (A, g. 5).
6. The cot has been correctly installed (g. 6).
Height adjustment
To change the height of the cot, two movements are required.
1. Li the upper part of the height adjustment handle (1, g. 7).
2. Press the buon on the handle.
Once the above is done, set the selected height while holding the stabilizaon
bar with your foot (g. 8).
There are ve cot heights available. It is also possible to set dierent heights on either
side. WARNING: The permissible maximum inclinaon of the cot is a dierence
of 2 levels. The child's head must always be on the side set in a higher posion.
Rocker funcon
To use the rocker funcon, move the locking handles (1, g. 9) and then li all
the wheels (2, g. 9) so that they are not in contact with the ground (g. 9). The
correct locking of the wheels in the selected posion will be signalled by the
click of the locking handle.
Wheel lock
To lock the wheels, press in the locks located on each wheel (A, g. 10). To
unlock the wheels, li the wheel locks (B, g. 10).