Lionelo Aurora - Advanced Usage and Care; Bedside Cot Conversion; Cover Removal and Cleaning Instructions

‑ 12 ‑EN
Bedside cot funcon
In order to use the bedside cot funcon, the product must be prepared accordingly.
To do so:
1. Unfasten the zips on both sides of the opening side (g. 1, g. 11).
2.
Slide the locks (2, g. 11) and remove the cot frame connecng piece (3,
g. 11).
3. Lower the side wall of the cot (g. 12).
4. Align the cot with the parents' bed and adjust the height of the cot so that
the parent's maress is of equal height or a maximum of 2 cm higher than
the top edge of the falling side of the cot (g. 16).
Note! The boom of the cot in the bedside cot funcon must be parallel to
the ground. A dierence in level between the sides of the cot is not permied.
5. Connect the mounng straps to the buckles on the side, next to the frame
of the cot (g. 13).
6.
Guide the mounng straps under the maress as indicated in the illustraon (g.
14), then ghten the straps to adjust their length to the parents' bed (g. 15).
7. Connect the mounng straps to the cot by fastening the buckles.
8. Make sure that there is no gap between the cot and the parents' bed and
that the cot is aached suciently rmly and stably to the parents' bed.
NOTE: Before each use, check that there is no space between the parents'
maress and the side wall of the cot.
WARNING: Use of the product is only permied with beds and/or maresses that
have straight sides. The use of the product next to beds and/or round maresses
and water maresses is prohibited.
Removal of cover
To remove the cover, lower the side wall of the cot and slide out the frame
connector piece (3, g. 11). Then unfasten the hook-and-loop fasteners located
on the falling side and slide out the sening board. Once this has been done,
using a zip fastener, detach the enre cover and slide it o the frame.
Cleaning and maintenance
• The cot cover and maress cover are hand-washable at 30°C.