Lionelo Hugo - Safety Seat Assembly; Seatbelt Assembly; ISOFIX System Assembly

‑ 9 ‑ EN
How to assemble safety seat
Assembly with seatbelt
1. Fastening seatbelts
• Place the safety seat on the car seat. Make sure the safety seat backrest ts
ght to the seat backrest (g. 7).
• Place the child in the safety seat.
• Pull the seatbelt, carry in front of the child and fasten it (8a).
2. Placing seatbelt in the safety seat handle
• From the seatbelt fastening side - carry the hip part through the red indicator
under the elbow rest (8a, 8e).
• The arm part must be carried above the elbow rest.
• On the other side – carry the hip part through the red indicator under the
elbow rest (8c).
• Remember that the hip part of the seatbelt must be carried as low of the
child’s hips as possible.
•
Carry the arm part of the seatbelt through the red handle in the headrest (8d).
• Make sure the arm part of the seatbelt goes through the collarbone, instead
of neck.
Assembly with ISOFIX system
1. Press buon on ISOFIX xing arm and pull it out as far as you can (g. 9).
2. Slip the safety seat in ISOFIX xing in the car unl you can hear clicks on
both sides. There should be a green buon on the arm (g. 10).
3.
Make sure the safety seat has been secured properly. If it scks out or moves,
repeat the assembly (g. 11).
Once you have assembled the seat, make sure that the safety seat has been
secured properly again:
1. Hip part of the seatbelt must go through red indicators under elbow rests
on the seat (g. 12-1).
2. Arm part goes above the elbow rest from the belt fastening side (g. 12-2).
3. Arm part of the belt goes through the handle under the headrest (g. 12-3).
4. Seatbelts are tense and must not be twisted.
5. Seatbelt fastening is not under the elbow rest (g. 13).