Lionelo Lars - Page 7

‑ 7 ‑ EN
Parts and ngs (front view) (g. 2)
1. Headrest
2. Headrest guide
3. Backrest
4. Safety seat base
Usage
1. Headrest adjustment
Pull the headrest up or push it down to the most desirable posion (g. 3).
Correct height of the headrest (g. 4).
2. The safety seat usage method for group II (from 15 to 25 kg):
Place the child in the safety seat in a way so that the back of the child
rests on the backrest. Place the lap part of the safety belt under the arm
rests, fasten the belt buckle and tension the belt. Pass the shoulder belt
under the arm rest. Then, slide it through the guide on the headrest.
Make sure the belt is not twisted on the child’s shoulders (g. 5).
Make sure all the lap straps are run low enough, in order to support the pelvis.
The belt must be passed through the belt guides with red signs.
Remove the headrest of the passenger seat. Otherwise, it may cause
dicules for the proper installaon of the safety seat.
Place the safety seat in the passenger seat making sure it is ghtly and
correctly secured in place (g. 6).
3. Backrest installaon / removal
Backrest installaon
Holding the boom of the backrest make the “U” shape and connect
it to the base. Then, adjust it so that it is in the vercal posion (g. 7).
Backrest removal
Push the backrest back and remove it.
4. The safety seat usage method for group III (from 22 to 36 kg):
Place the child in the safety seat in a way so that the back of the child