Lionelo Lars - Maintenance

‑ 8 ‑EN
rests on the backrest. Place the lap part of the safety belt under the arm
rests, fasten the belt buckle and tension the belt. Pass the shoulder belt
under the arm rest. Then, slide it through the guide on the headrest.
Make sure the belt is not twisted on the child’s shoulders (g. 5).
Make sure all the lap straps are run low enough, in order to support the pelvis.
The belt must be passed through the belt guides with red signs.
Maintenance
• To maintain protecve properes of the product
•
Do not allow it to come into contact with pastes, oils, bleaching
agents or any other chemicals.
• Any collision at speeds above 10 km / h may cause damage to the
safety seat, which is not always visible. In this case, the safety seat
must be checked by the manufacturer and replaced if required.
•
To ensure proper operaon of all mechanical components regularly
check all important parts for damage.
• If the safety seat is damaged (for example aer being dropped) it
must be checked by the manufacturer or the retailer.
How to remove the fabric cover
Detach the Velcro straps at the back of the safety seat. Now, you can
remove the fabric cover.
Cleaning:
The fabric cover for Lionelo safety seats can be replaced only with original
covers or the ones recommended by the manufacturer as it is an integral
part of the product, important for the proper funconing of the system.
• Do not use the safety seat without the fabric cover.
•
The cover can be removed and cleaned with a mild detergent in
a washing machine (delicate cycle- up to 30°C).
Clean the plasc parts with a damp cloth (warm water and soap). Do not
use chemicals, bleaching agents or any corrosive substances.
Always follow the instrucons on the label.