Lionelo Leonie - Parts Identification; Assembly Instructions

‑ 7 ‑ EN
4. Do not use other xing systems than described in the manual.
5. Never use the bedside sleeper if it is inclined.
6. To avoid suocaon risk, always aach the bedside sleeper
to the parents’ bed with the use of xing systems described
in the manual.
7. There must not be any free space between the lower part of
the bedside sleeper and adult bed’s maress.
8. Before every use, check the bed xing system tension. To do
so, try to pull the bedside sleeper away from the parents’ bed.
9. If there is free space between the bedside sleeper and adults’
bed, DO NOT USE the product.
10. The gap between the bedside sleeper and adults’ bed must
not be lled with pillows, blankets and other items.
11. DANGER! Always completely raise the drop side when not
aached to the adult’s bed.
12. WARNING: To avoid hazards from the child’s neck being
caught on the top rail on the side that is next to the adult bed,
the top rail must not be higher than the adult bed maresss.
13. WARNING: To avoid the risk of your child being strangled
the aachment system to the adult’s bed shall always be kept
away from and out of the crib.
1. Descripon of parts from the box (see g. 1):
1. Carrycot
2. Maress
3. Frame legs (x2)
4. Support
5. Supporng belt (x3)
6. Screw (x4)
7. Allen bolt
2. How to assemble
• Connect the support (C) to frame legs (A and B) as showed by arrows in the
gure. Connectors are equipped with locking screw holes (6). To ghten up
screws, use the Allen bolt (7) (see g. 2).
•
Connect the frame of the carrycot to the frame of the base (with two fasteners)
unl you can hear a „click” and the frame engages. Next put the maress (2)
into the crib (see g. 3).