Lionelo Mona - Page 11

‑ 11 ‑ EN
1. Put 4 legs of the low chair (E), front (RR, LL) and rear (L, R) in spots marked
in the seat base (L), front and rear (R, L, R, L), unl you hear a characterisc
click (g. 10).
2.
Fix 2 metal connectors of the low chair (F) between low legs, aach
connectors with 4 screws (N) to the chair legs. To do so, use the Allen key
(O). Assemble the footrest (J) to nish the procedure (g. 11).
3.
Put the seat with backrest (K) into the seat base (L), and then put the plasc
tray on (I), unl you hear a characterisc click (g. 12).
4. Put the top silicone tray on (P).
5. Check if the chair is stable (g. 13).
6. Put the child in and secure with 5-point belts located the seat covering.
How to aach the booster seat (2) on the chair:
Aach the booster seat with two xing belts supplied. Follow the steps below:
1. Assembly of the booster seat (2) with the use of a xing belt (M) on the
chair through the seat boom (K) (g. 14):
• Carry the belt (M) through two holes in the seat boom (K) (g. 15).
•
Carry the belt through the adult chair and lock the buckle, next ghten the
belt to have a relevant length (g. 16).
2. Assembly of the booster seat (2) with the use of a xing belt (M) on the
chair through the backrest (K) (g. 17):
• Carry the belt (M) through two holes in the seat backrest (K) (g. 18).
•
Carry the belt through the adult chair and lock the buckle, next ghten the
belt to have a relevant length (g. 19).
•
Check if the booster seat has been properly posioned with the use of
the xing belt (g. 20).
• Put the child in and secure with 5-point belts located in the seat covering.
Suitable sizes of the chair for assembly of the booster seat
on the chair:
Pay aenon to the following sizes of the adult chair:
1. Chair width must not be lower than 33,8 cm.
2. Chair depth must not be lower than 28 cm.
3.
Chair backrest height must not be lower than 42 cm and higher than 63 cm.