Lionelo NOA PLUS - Page 9

‑ 9 ‑ EN
in the vehicle’s safety buckle. Pull the belt to make sure it is properly secured in
the buckle (g. 8b).
Step 3: Hook the shoulder part of the belt in the guide located at the rear side
of the baby seat’s back (g. 9).
Step 4: Tighten the 3-point seat belt by pulling it as it is shown in the picture
(g. 10a).
Aer all these steps the baby seat is properly installed and secured (g. 10b).
Make sure that the belt hasn’t twisted during the installaon and it is properly
ghtened.
To remove the baby seat from the car, please follow the above steps in reverse
order.
5.4 Changing the handle’s posion
The seat’s handle can be placed in 4 dierent posions. In order to change the
posion, press the red buons at the both sides of the baby seat simultaneously.
The buons are located in the side corners of the baby seat (g. 11, 12).
You can place the handle in 4 dierent posions:
1.
It is the only posion you can use while mounng the baby seat on a vehicle’s
seat.
2. Basic posion - you can choose it to carry a child.
3. Resng posion - use it to freely put a child in/out of the baby seat.
4. Base posion - ideal when you feed or play with a child.
Each me you change the handle’s posion make sure it has been properly
secured (locked).
5.5 Using the hood (g. 13)
The handles at the ends of the frame are adjustable. “Click” sounds indicate that
the hood has been properly folded / unfolded.
5.6 Maintenance
The cover can be easily removed for cleaning. In order to do so, rst pull the
straps out of the baby seat. Then remove the cover.
Cleaning: Straps and plasc parts can be cleaned with mild detergents and warm