EasyManua.ls Logo

Lionelo Oliver - ISOFIX and Top Tether Installation Methods; ISOFIX & Top Tether Assembly (Group 1); ISOFIX Assembly (Groups II & III); ISOFIX with Car Seat Belt Assembly

Lionelo Oliver
112 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
‑ 13 ‑ EN
8.
Fasten the car safety belts (g. 16). Check if the child safety seat has been xed properly.
Make sure the shoulder part goes through the child’s collarbone, not its neck. The hip belt
must be posioned as low as possible.
With ISOFIX and TOP TETHER
Group I (9 – 18 kg)
The child secured with child safety seat belts.
1. If necessary, put both ISOFIX pads (W) on car xing points.
2. Press ISOFIX buons (V) to pull out the connecng arms (U). Pull them out as far as
you can and then connect to car xing points. Press the child safety seat against the
car seat as much as you can, ISOFIX handles should anchor. ISOFIX indicators should
be green on both ISOFIX arms (g. 19).
3. Pull out TOP TETHER belt and then stretch it more with the adjustment (T). Fasten the
handle in the place recommended in the vehicle manual (g. 20). Tighten TOP TETHER
up with the adjustment (T). The upper xing belt is properly ghtened when you can
see a green indicator on the buckle.
4. Place the child in the child safety seat and secure with child safety seat belts.
Note! The upper belt fastening point may dier, depending on the car, The gure 20 shows
examples of ways of xing, depending on car model.
Groups II and III (15 – 36 kg)
The child safety seat belts are disassembled. The child is secured with car safety belts.
1.
Disassemble 5-point child safety seat belts (see: „HOW TO DISASSEMBLE CHILD
SAFETY SEAT BELTS”).
2. Remove the seat liner (J).
3. Press ISOFIX buons (V) to pull out the connecng arms (U). Pull them out as far as
you can and then connect to car xing points. Press the child safety seat against the
car seat as much as you can, ISOFIX handles should anchor properly. ISOFIX indicators
should be green on both ISOFIX arms.
Next take one addional step - A or B. Installaon with ISOFIX handles only is forbidden!
A. ISOFIX + Car seat belts
1. Put the child in the child safety seat.
2. Pull the car seat belt.
3. Carry the shoulder belts through the guide in the headrest (A).
4. Carry the hip part of the belt through the hip belt guide (M).

Related product manuals