ISOFIX top strap installation
ISOFIX
·
TOP STRAP
Attaching the top strap
to the fixing points:
In most vehicles the fixing
point is located on the rear
windscreen panel, behind
the back seats.
This fixing point is located on
the boot floor, behind the back
seats.
The connector is located right
under the vehicle’s seats.
You need to fold down the
seats to find it.
The fixing point is located
at the rear side of the
vehicle’s back seats.
Make sure that the ISOFIX connectors
are installed correctly.
Press the top strap adjuster button and pull
the top strap in or out to adjust it.
The top strap adjustment can increase
the fixing strength. However, it’s not
suitable in case of some vehicles
(including those equipped with ISOFIX
connectors). The position of the fixing
points may vary depending on a given
vehicle.
In order to install the safety seat as
firmly and properly as possible,
please refer to the information in the
vehicle’s manual.
Make sure that the strap is not twisted and
lock it in the vehicle’s ISOFIX
connector.
Pull out the adjustment end of the top
strap in order to tighten the safety
seat firmly to the vehicle’s seat.
Vehicle’s icons indicating the fixing point and the connector
The top strap is properly installed
when the indicator on the adjuster
turns green.
If there is no green indicator on the
top adjuster, or it is covered, it means
that the safety seat mount is not firm
enough, or it has been installed
improperly. In that case you need to
install the top strap again.
To Next Page
Loading...
