Lionelo Sven Plus - Changing Table and Organizer Assembly; Folding and Cleaning Procedures

‑ 9 ‑ EN
top to get rid of the pointed shape, which is picked up in the carton (see g. 7, 8).
The mosquito net may only be used with the canopy folded out. If you want to fold
the canopy - detach the mosquito net.
Changing table assembly instrucon
Slide the sening tubes into the cloth rewinders. Combine them with addional pipes
with plasc fasteners. Fasten the material with all the naps, pull it rmly on the resulng
frame. Insert the plasc fastening elements on the longer sides of the cot, insert addional
fasteners in the shorter side of the bed. Fasten the organizer’s naps on dedicated places
on the bed frame, stretching the organizer’s material at the changing table (see g. 9).
Organizer installaon
Put the hooks on the organizer and mount it on the bed frame (see Fig. 11a, 11b).
Baby bed folding instrucon
1. Remove all the bed accessories. Remove the maress, canopy, organizer and
all the other accessories. Grasp the centre handle located in the middle of
the oor and pull it up (see g. 12).
2. To unlock the upper rails, press the indicated buons on each side of them.
Pull it slightly up and then push it down. Unlock the shorter sides rst, and
then do the same with the longer ones.
3. While sll pulling up the handle, li the oor of the baby bed and fold the
legs (see g. 13).
4.
Wrap the folded bed with the maress and fasten it with Velcro straps.
Put the folded baby bed into the bag (see g 14, 15.).If the installaon is
unsuccessful, repeat the whole process again unl submission
Cleaning
Wipe the product with a damp cloth, then allow to dry.
Changing table - clean with warm water and mild soap. Do not dry clean and do
not use causc agents. Do not dry mechanically, do not iron.
The product has been tested and meets all the requirements of the:
EN 716-1:2017+AC:2019, EN 12221-1:2008+A1:2013