Lionelo Theo - Installation Instructions; Assembly Steps Overview; Moving the Bed

‑ 6 ‑EN
7. There shall never be a gap between the lower side of the
bedside sleeper and the maress of the adult bed.
8. Check the ghtness of the aachment system before each
use by pulling the bedside sleeper in a direcon away from
adult bed.
9. If there is a gap between the bedside sleeper and the adult
bed DO NOT use the product.
10. Gaps should not be lled with pillows, blankets and other
items.
11. DANGER! Always completely raise the drop side when not
aached to the adult’s bed.
12. WARNING: To avoid hazards from the child’s neck being
caught on the top rail on the side that is next to the adult bed,
the top rail must not be higher than the adult bed maress.
13. WARNING: To avoid risk of your child being strangled the
aachment system to the adult’s bed shall always be kept
away from and out of the crib.
Installaon instrucons
1. Combine both frame legs with a connecon tube (g. 1).
2. The connectors have special screw holes. Use an Allen key to ghten the
screws (g. 2).
3. Connect the base frame with the gondola frame (g. 3).
A. Gondola
B. Gondola frame connector
C. Height adjustment buon
D. Bed frame
4. Aach the front rail to the gondola frame, and then fasten the side zippers
(g. 4).
5.
Press the height adjustment buon and set a desirable height level. The
bed can be posioned in one of 5 height levels available. It is also possible
to set dierent height at each side (g. 5).
6. Press the buon down and pull the leg out/in to adjust its length. There are
two posions available (g. 6).
7. Moving the bed
Hold the back rail of the gondola, then li and push it to move the bed. The rear