Lionelo Theo - Attaching to a Bed; Maintenance and Care

‑ 7 ‑ EN
leg caps are non-slip, which prevents the baby bed from undesirable moving (g. 7).
8. Aaching to a bed
The baby bed can be aached to a parents’ bed. In order to do so, unzip
the side zippers completely, open the side of the baby bed and slide the rail
out of the mounts, as shown in the picture (g. 8).
9. Move the baby bed to a parents’ bed and check the height of the baby bed
in relaon to the parents’ maress.
10.
Use the included belts to aach the baby bed to a parent’s bed. Place the buckle
in the connector plug at the boom of the gondola, run the belt from boom
to top around the parents’ bed construcon, and then fasten the buckle.
The loop should be as ght as possible. You can adjust the length of the belt
with the clip in the middle. Repeat it for the other belts (g. 9, 10).
CAUTION: Before each use, make sure there is no gap between the parents’
maress and the side wall of the baby bed.
WARNING: The product can ONLY be aached to beds and/or maresses with
straight sides. Do NOT use the product with round or water beds and/or maresses.
WARNING: The maximum permissible inclinaon of the baby’s bed is a dierence
of 2 levels. The child’s head must always be higher than other parts of the body
Maintenance
• Clean the plasc parts with a so cloth.
• The maress can be cleaned with a damp cloth and natural cleaners.
• Do not use bleach to clean the product.
• Do not iron.
• Do not dry clean.
• Do not tumble dry.
• The fabric parts can be washed by hand (in up to 30ºC).
The product has been tested and meets all the requirements of the following
standards: EN 1130:2019+AC:2020, EN 16890:2017+A1:2021
The pictures in this manual are for illustrave purposes only. Therefore, they may dier
from the actual product.