Lionelo Thermup - Bottle Warmer Operations; Defrosting and Heating

‑ 7 ‑ EN
List of parts (g. A)
Defrosng
1.
Place a bole or container with food in the warmer (g. 1).
2. Pour water into the warmer unl you reach food or milk level. In case of a large
amount of food or milk, the maximum amount of water in the warmer is about 1,5
cm below the upper edge of the device (g. 2).
3. Choose defrost/quick heat in the display (g. 3). Wait for the status LED to glow.
NOTE
Due to high diversity of baby food consistency, it is advisable to frequently sr and
inspect the temperature of food defrosted.
Do not serve milk/food shortly aer defrosng.
Quick heang
1.
Place a bole or container with food in the warmer (g. 1).
2. Pour 40 ml of water into the warmer (see: table below) (g. 2).
3. Select defrost/quick heat in the display (g. 3). Wait for the status LED to glow.
4. Do not heat frozen milk or food. Remember to heat milk or food aer defrosng.
NOTE
In case of quick heang, use the device together with a cover.
Bole Inial temp. Amount of
water
Amount of milk
60ml/2oz 120ml/4oz 180ml/6oz 240ml/8oz
Glass 4°C/41°F
40ml/1.4oz
3 min 4 min 5 min 6 min
20°C/68°F 2,5 min 3 min 4 min 4,5 min
Plasc 4°C/41°F 4 min 5,5 min 6 min 7 min
20°C/68°F 3 min 3,5 min 4,5 min 5 min
Milk heang
1. Place a bole with milk or water in the warmer (g. 4).
2. Pour water into the warmer unl you reach milk or water level in the bole. In case
of a large amount of water or milk, the maximum amount of water in the warmer
1. Cover
2. Bole/container holder
3. Warmer
4. Status LED
5. Defrost/quick heat
6. Milk heang
7. On/o switch
8. Value up
9. Food heang
10. Disinfect
11. Change mode
12. Value down