Lionelo Thermup - Advanced Operations and Maintenance; Food Heating, Disinfection, and Cleaning; Descaling Procedure

‑ 8 ‑EN
is about 1,5 cm below the upper edge of the device (g. 5).
3. Select heang in the display (g. 6). Wait for the status LED to glow.
4. Heang me may vary, depending on the amount of milk or water and inial
temperature.
NOTE
It is advisable to serve milk to the child shortly aer heang. Avoid milk reheang.
Always check milk temperature before you serve it to the child (g .7).
Food heang
1.
Place a container with food in the warmer (g. 8).
2. Pour water into the warmer unl you reach food level in the container. In case of
a large amount of milk or water, the maximum amount of water in the warmer is
about 1,5 cm below the upper edge of the device (g. 9).
3. Select food heang in the display (g. 10). Wait for the status LED to glow.
4. It is advisable to sr food while heang (g. 11).
5. Before serving, always check food temperature (g. 12).
NOTE
Due to high diversity of baby food consistency, it is advisable to frequently sr it and
inspect the temperature. It is not possible to precisely specify food heang me.
Disinfecng
1.
Before you start disinfecng, wash and carefully rinse the bole and accessories.
2. Place accessories and a bole upside down in the warmer (g. 13).
3. Pour about 50-100 ml of water into the warmer (g. 14).
4. Select disinfecon in the display (g. 15). Wait for the status LED to glow.
5. When water evaporates, the device shuts down automacally.
Cleaning
1. Aer every use and before cleaning, unplug the device. Wait so that the device
can cool down before you start cleaning.
2. Remove water from the device (g. 16).
3. If you have heated food in the device, make sure there are no remains at the boom.
4. Wipe the housing and interior of the warmer with a so wet cloth, and then wipe
it dry with a clean cloth or paper towel (g. 17).
5. For cleaning, do not use scrub sponges, scrub agents or any other causc substances
or chemicals.
Descaling
1.
It is advisable to perform descaling on a regular basis, that is every four weeks, to
assure correct operaon of the device.
2. Pour 50 ml of white vinegar and 100 ml of cold water into the device.
3. Turn the device on and then select milk heang. Let the device work for 10 minutes.
4. Leave the soluon in the device unl descaling is successful.