Lippert 285318 - Power Tongue Jack Kit Components; Pre-Installation Steps

3
lippert.com 432-LIPPERT (432-547-7378) Rev: 12.15.21
Power Tongue Jack
Installation and Owner’s Manual
(For Aftermarket Applications)
CCD-0004287
Power Tongue Jack Aftermarket Kit PN Power Tongue Jack Aftermarket Kit PN 285318
LetterLetter PNPN
DescriptionDescription QtyQty
A 181794 Power Tongue Jack 1
116112 Manual Crank Handle (replacement
crank handle may vary in style)
1
Replacement Parts Available
B
117919 3/8” - 16 x 1” Bolt 1
C
165253 Footpad 1
D
118105 Cotter Pin 1
E
382844 Clevis Pin 1
F
285324 Crank Handle (may vary in style) 1
Parts List
NOTE: Part numbers are shown for identification purposes
only. Not all parts are available for individual sale. All parts
with a link to the Lippert Store can be purchased.
Prior to Installation
1. Remove the footpad from the Power Tongue Jack
(if necessary).
A. Remove the hairpin cotter pin (Fig.1D) and clevis pin
(Fig.1C) holding the footpad (Fig.1B) to the jack leg (Fig.1A).
Set the pins and the footpad aside.
2. Support the trailer according to OEM instructions.
THE TRAILER MUST BE SUPPORTED PER
MANUFACTURER’S RECOMMENDATIONS BEFORE
WORKING UNDERNEATH. FAILURE TO DO SO MAY
RESULT IN DEATH OR SERIOUS INJURY.
Fig.1
A
F
A
B
C
D
B
C
D
E
NOTE: Make sure to inspect the packing material, front,
back and underneath for all Power Tongue Jack parts.