Rev: 08.18.21 Page 28 CCD-0004099
14. Lower the curbside patio railing assembly (Fig. 75A) approximately 45 degrees down towards the
center of the ramp door.
15. Fold the front panel (Fig. 75B) over the top of the side patio railing (Fig. 76A) and let the patio railing
return to the 90 degree position (Fig. 77).
Fig. 75
Fig. 76
A
B
Fig. 77
16. Attach the snap (Fig. 77A) that holds the front panel to the curbside railing.
17. Attach the curbside rear bungee cable (Fig. 77B) to the footman loop (Fig. 77C) located on the
door jamb.
A
B
C
A
To Next Page
Loading...