Lippert Furrion FWH09A-AM User Manual (English)

Questions and Answers:

S
Steven DeleonAug 8, 2025
What to do if there is no hot water at the tap in my Lippert Furrion FWH09A-AM?
- D
  Deborah HillAug 9, 2025
  If you're experiencing no hot water at the tap with your Lippert Water Heater, there are several potential causes. First, ensure that the gas supply is turned on. Refill or replace the gas tank if it's empty. Check that the fresh water supply is open and the appliance is switched on according to the operating procedures. Also, verify that the power supply to the appliance is switched on. If none of these steps resolve the issue, there may be a defect in the appliance.
M
Maria MannAug 12, 2025
Why is the hot water temperature too low in my Lippert Furrion FWH09A-AM Water Heater?
- G
  greenepennyAug 12, 2025
  If the hot water temperature is too low in your Lippert Water Heater, several factors could be the reason. It could be that the gas flow to the appliance is too low. Also, the volume flow of hot water might be too high, or the cold water reaching the appliance is too cold; in this case, try turning down the hot water at the tap or mixing more cold water in the faucet. Another possibility is that cold water is mixing into the hot water side; in this case, check all valves to ensure they are closed. Too much lime scale in the appliance can also cause this problem, so decalcify your water heater.
D
davidcareyAug 17, 2025
What to do if water is escaping at pressure safety valve in my Lippert Furrion FWH09A-AM?
- J
  johnsonamandaAug 17, 2025
  If water is escaping at the pressure safety valve of your Lippert Water Heater, it could be due to high water pressure in the water system. Adjust the water pump pressure to a maximum of 65 PSI. If connected to a central water supply exceeding 65 PSI, install a water pressure regulator at the fresh water supply. Alternatively, lime or dirt under the pressure relief valve seat might be the cause. Allow the appliance to cool, then slowly operate the relief valve to flush the system and attempt to force out any foreign matter.
V
Veronica MahoneyAug 21, 2025
Why does hot water take longer to reach temperature in Lippert Furrion FWH09A-AM Water Heater?
- E
  Ellen RogersAug 22, 2025
  If hot water takes longer to reach temperature in your Lippert Water Heater, it might be due to cold water mixing into the hot water side. Check all valves, inside and outside, to ensure they are closed, and also check the shower head valve to make sure it is not partially closed. It could also be normal due to higher elevation. In some cases, the incoming water temperature may be abnormally low.
B
Brittany ValenciaAug 26, 2025
What to do if the power status LED is off on my Lippert Water Heater?
- A
  Amber CookAug 26, 2025
  If the power status LED is off on your Lippert Water Heater, even after selecting an operating mode, it could be that the power supply to the appliance is switched off. Ensure the power supply is on. Another possibility is a blown fuse; in that case, replace the standard 125V/10A fuse.
N
Nicholas HarrisAug 30, 2025
Why is water leaking at the water inlet filter of my Lippert Furrion FWH09A-AM Water Heater?
- R
  Robert VelazquezAug 30, 2025
  If water is leaking at the water inlet filter of your Lippert Water Heater, it's likely due to lime or dirt under the O-ring seats. Clean the O-rings and their corresponding sealing surfaces with clean water.
M
millsdennisSep 3, 2025
How to fix low hot water flow at the faucet in Lippert Water Heater?
- L
  lesterchelseaSep 3, 2025
  Low hot water flow at the faucet in your Lippert Water Heater may be caused by lime scale due to precipitation of hard water. Decalcify your water heater.

Lippert Furrion FWH09A-AM Specifications

General

Model	FWH09A-AM
Type	Tankless Water Heater
Fuel Type	Propane
Dimensions	12.75" H x 12.75" W x 5.25" D
Weight	25 pounds
Ignition Type	Electronic
Voltage	12V DC
Water Tank Capacity	Tankless

Lippert Furrion FWH09A-AM User Manual

Table of Contents

Questions and Answers:

Lippert Furrion FWH09A-AM Specifications