Lippert HAPPIJAC - Adjustments; Timing Adjustment Procedure

Rev: 06.30.22 Page 10 CCD-0001575
Fig. 14
Adjustments
Timing
Resources Required
• Tape measure
•
½
" Socket wrench
To make sure all four corners of the HappiJac Bedlift latch and unlatch properly, the non-motor side (Fig.
14A) of the bedlift system should be set
¼
" to
½
" higher than the motor side. To adjust the timing:
1. Press the DOWN switch to lower the bedlift system until it stops.
2. Measure from the bottom of the lower trolley sofa bracket (Fig. 15A) to the bottom of the C-channel (Fig. 15B).
Fig. 15
B
A
A
A
3. Unplug the motor from the relay control module (Fig. 16A).
4. Release the brake by moving the release level to the "OFF" position (Fig 16B).
Fig. 16
Motor
Cross-connecting
Shaft
B