Name: Liquiflo MAX Series
Brand: Liquiflo
Rating: 4 (1 reviews)

Questions and Answers:

T
turnernathanielAug 1, 2025
How to troubleshoot no discharge in Liquiflo MAX?
- J
  julie26Aug 1, 2025
  If your Liquiflo Water Pump has no discharge, several factors could be the cause. First, make sure the pump is primed by verifying the suction pipe is submerged, increasing suction pressure, and opening the suction valve. Check that the motor rotation is correct by reversing the motor leads. Ensure all suction and discharge valves are open and the bypass valve is closed. Look for air leaks in the suction line; if present, tighten connections and apply sealant to all threads, also verify the suction pipe is submerged. Clean the strainer if it's clogged. If none of these steps work, the pump may be worn or damaged, requiring a rebuild.
J
Jesus FloydAug 5, 2025
What to do if Liquiflo Water Pump has insufficient discharge?
- K
  Katherine WebbAug 5, 2025
  If your Liquiflo Water Pump has insufficient discharge, consider these potential causes and solutions. Ensure that the suction pressure isn't too low by increasing it, verifying the suction piping isn't too long, and fully opening any suction valves. Check that the bypass valve is closed. Clean the strainer if it's partly clogged. If the speed is too low, increase the driver speed if possible, or consider using a larger size pump if required. If the issue persists, the pump may be worn or damaged and require rebuilding.
J
Jeremy SandovalAug 9, 2025
Why is my Liquiflo Water Pump making excessive noise and vibration?
- M
  Monique WardAug 9, 2025
  Excessive noise and vibration in your Liquiflo Water Pump can stem from several sources. Ensure that the suction and/or discharge piping are anchored and properly supported according to Hydraulic Institute Standards. Check that the base is rigid enough by tightening hold-down bolts on the pump and motor or adjusting stilts, and inspect/regrout if necessary. Worn pump or motor bearings can also cause this issue, so replace them as needed. Finally, pump cavitation could be the culprit; try to increase the NPSH available.
F
Francisco HowellAug 13, 2025
What causes excessive power consumption in Liquiflo Water Pump?
- E
  Emily LeeAug 13, 2025
  Excessive power consumption in your Liquiflo Water Pump may be due to several reasons. If the fluid viscosity is higher than specified, heat the fluid to reduce viscosity, reduce pump speed, or increase driver horsepower. If the differential pressure is greater than specified, increase the pipe diameter. Insufficient gear clearances for the fluid viscosity or plastic gear clearance for fluid temperature can also cause this; purchase gears trimmed for the correct viscosity or temperature, respectively. Lastly, rotating parts binding or severely worn may be the cause, requiring disassembly and replacement of worn parts.