3. Once all the connections have been made, carefully turn on the water supply and
check for any leaks.
4. Make sure that the new water inlet hose is not pinched, twisted, bent, kinked or
crushed.
• If the machine has a hot water inlet connection, the temperature of the water
supply must not exceed 70°C
•
NOTE: The appliance must be connected to the water supply network using
the new connection kits provided with the appliance. Do not re-use old collection
kits.
CONNeCTINg The dRAIN hOSe
• Connect the drain hose to a drain pipe or to the drain trap of a sink using additional
ttings.
• Never attempt to extend the drain hose.
• Do not place the end of the machine's drain hose in a container, bucket or tub.
• Make sure that the drain hose is not kinked, twisted, crushed or overly extended.
• Fit the drain hose at a maximum height of 100 cm above the ground.
EN
41 V.1.0
To Next Page
Loading...
